Stainless Steel Interface Single Point Float Switch Ktech Model FS601-I-HT-125C

Ktech Model FS601-I-HT-125C Single Point Stainless Steel Interface Float Switch

The FS601-1-HT-125C Stainless Steel Interface Float Switch is activated by an interface float that is weighted to float on water and sink in oil. Switch set-point distances are field adjustable by using an extension pipe. The lead wires must be ordered to a suitable length in order to pass through the extension pipe. Standard lead wire length is 120”. The switch must be connected in series with a load. The contact arrangement may be changed from normally open (NO) to normally closed (NC) and vice versa. Remove the stop collar and turn over the float and then return the stop collar to the original position. If the contact arrangement is altered use an ohmmeter to test that the switch operatec correctly The switch must be connected in series with a load.

Model FS601-I-HT-125C Construction

• 1/2 O.D. 316 Stainless Steel Stem

• 2" Diameter Stainless Steel Interface Floats (0.93)

DO NOT CONNECT THE SWITCH DIRECTLY ACROSS THE POWER SUPPLY.

The voltage / current product must not exceed the power rating.

Model FS601-I-HT-125C Specifications

• Maximum Switching Voltage
  VOLTS DC/AC - 120

• Maximum Switching Current
  AMPS DC/AC - 1.0

• Maximum Switching Power
  WATTS DC/AC - 100

• Operating Temperature Range. -25ºC to 125ºC (-13ºF to 257ºF)

	LISTED OVERFILL PROCTECTION DEVICES 4YC9
	Meets Standards: Class 1 Division 1, Groups B,C,D CSA C22.2 No. 1010-1 and ANSI /I SA S82-03 CSA C22.2 No. 30 and UL1203

FS601-I-HT-125C Stainless Steel Interface Float Switch
FS601-I-HT-125C Stainless Steel Interface Float Switch